# File: /home/sinfoni/.esorex/sinfo_rec_detlin.rc
#
# Note: This configuration file has been automatically
#       generated by the esorex (v3.6) program.
#
# Date: 08-Jan-2007 08:52:34
#
#

# --bp_lin-order
# Order: order of the fit polynomial = number of coefficents - 1. This option
# may also be set using the environment variable sinfoni.bp_lin.order.
sinfoni.bp_lin.order=2

# --bp_lin-thresh_sigma_fct
# Threshold Sigma Factor: threshold factor of the clean standard deviation. If
# the deviations of the linear polynomial coefficients exceed this threshold
# the corresponding pixels are declared as bad. This option may also be set
# using the environment variable sinfoni.bp_lin.thresh_sigma_factor.
# Value set to 20.0 on 2007-02-09 due to huge amounts of non-linear pixels
# being computed from high-count linearites in S1_J setup.
# sinfoni.bp_lin.thresh_sigma_factor=20.0
# After 2007.02.22 the linearity lamps have been set to normal, lower values,
# so I have put it back to its normal value of 10.0
#
sinfoni.bp_lin.thresh_sigma_factor=10.0
#sinfoni.bp_lin.thresh_sigma_factor=20.0

# --bp_lin-nlin_threshold
# Non Linear Threshold. This option may also be set using the environment
# variable sinfoni.bp_lin.nlin_threshold.
sinfoni.bp_lin.nlin_threshold=0.5

# --bp_lin-lo_rej
# low_rejection: percentage of rejected low intensity pixels before averaging.
# This option may also be set using the environment variable
# sinfoni.bp_lin.low_rejection.
sinfoni.bp_lin.low_rejection=10.0

# --bp_lin-hi_rej
# high_rejection: percentage of rejected high intensity pixels before averaging.
# This option may also be set using the environment variable
# sinfoni.bp_lin.high_rejection.
sinfoni.bp_lin.high_rejection=10.0

#
# End of file